Replacement
components for 15 ppm Bilge Oil Alarms.General
All monitors in our range are
inspected and tested to I.M.O. requirements at our factory prior to
delivery. In normal use the units should operate correctly and without
fault over a long period of time requiring only small amounts of
maintenance to be carried out as outlined in the instruction manuals.Service Exchange Units
In the event of a monitor
malfunction due to electrical or electronic component failure it is our
recommendation that a service exchange unit be ordered. The
defective instrument should be returned to our works within 30 days of
supplying the service exchange unit, then only the repair charge is
payable. Otherwise the whole cost of a service exchange unit becomes
payable. This
procedure is by far the easiest and most cost effective way of ensuring
the monitor on board conforms to I.M.O. resolution MEPC.60 (33).Component Replacement / Repair
When replacing or repairing
electronic components (except fuses) please note that due to varying
component performance characteristics it may be necessary to re-adjust or
calibrate the monitor. Failure
to carry out the correct procedure could result in the monitor over or
under reading which in turn could lead to oil pollution and the
consequences that follow. In
order to avoid this potential problem we can only advise that a service
exchange unit be supplied.
Services